.sbttl	KRTXM	Build KM for RT-11XB,XM,ZB,ZM

;	27-Sep-97  Billy Youdelman  V03.63

	mmg$t	= 1	; if <> support extended memory
	tsx$p	= 0	; if <> support TSX-Plus
	tim$it	= 0	; these two MUST match the monitor as it is or
	erl$g	= 0	; RT-11 V5.5 or above will not load this handler!

;	If you are unsure of whether erl$g and tim$it are in the RT-11
;	monitor(s) to be used, boot each in question and use RESORC to
;	check:
;
;	.RESORC/O
;
;	If you see:			Then:
;	Device I/O timeout support	you must make tim$it = 1
;	Error logging support		you must make erl$g = 1
;
;	If the interface supports programmable speed selection,
;	enable it by making its type = 1 here.  Otherwise, make
;	the following three = 0.  These are mutually exclusive,
;	up to one and only one may be used at a time:

	km$dve	= 0	; if <> DL(V)-11/E interface
	km$pro	= 0	; if <> PRO-series modem interface
	km$sbc	= 0	; if <> Falcon interface

	km$csr = 176500	; if not PRO-series, desired CSR
	km$vec = 300	; and interrupt vector (PRO defaults are in KRTKM.MAC)

;	Speed default, select one of the following:

;	km$spd = 300.
;	km$spd = 1200.
; 	km$spd = 2400.
;	km$spd = 4800.
	km$spd = 9600.		; <default>
;	km$spd = 19200.
;	km$spd = 38400.		; Falcon ONLY